SiWave提示：Pre-setup Validation Error

2017-06-19  by:CAE仿真在線  來源:互聯網

使用SIwave時出現的問題Pre-setup Validation Error:

Simulation Status

  Simulation "SYZ Sweep 1" started on host myPC at Mon Jun 19 15:42:28 2017
  SYZ solver completed with return code 1
  Simulation "SYZ Sweep 1" terminated on host myPC at Mon Jun 19 15:42:28 2017 with exit code 1
Pre-setup Validation Error

  SIwave analysis mandates that at least one plane be present in the geometry

Simulation "Resonant Mode mysi abc" started on host PCASUS at Mon May 09 12:30:03 2017   Simulation "Resonant Mode mysi abc" terminated on host PCASUS at Mon May 09 12:30:03 2017 with exit code 1 Pre-setup Validation Error   SIwave analysis mandates that at least one plane be present in the geometry 這個問題要怎么解決? 很明顯,這是因為缺少了plane,一個SIwave分析模型,至少包含一個平面,否則SIwave無法進行計算 可惜這個錯誤雖為預先設置檢查錯誤,但是在check validation中并未包含,只在run的過程中才會出現,一旦出現運算就會終止運行

   SIwave的Pre-setup Validation Error一般是模型欠缺,不滿足基本的分析前提條件所致。

——仿真在線(1cae.com)

轉載請注明出處:網址http://www.zhanghuihuang.cn

相關標簽搜索：SiWave提示：Pre-setup Validation Error ansysem電磁培訓班 ansys SIwave培訓課程 ansys maxwell hfss培訓和分析 ansysem在線視頻教程 pcb 封裝分析仿真 Fluent、CFX流體分析 HFSS電磁分析 Ansys培訓 Abaqus培訓 Autoform培訓 有限元培訓